BLOCKsignalling ASP1-NS Light Aspect Controller No Soldering

BLOCKsignalling Show reviews

Availability: In Stock Out Of Stock

£16.99 £0.00
Earn 16 Rewards Points

Want to be notified when this product is back in stock? Complete the form below and we'll send you an email when it is.

The Best Way to Automatically Operate your LED Model Railway Signals Controlling multi-aspect signals on model railways has never been easier Detects trains passing signals using its in-built infra-red sensor Operates from 12V to 25V DC, 12V to 16V AC, or uses DCC as a power feed and feeds signals at 12V Fades leds in and out to simulate incandescent bulbs Very simple to connect up to signals No soldering required, all components are ready wired-up No programming required (but you can adjust all settings if you wish) For use with common-cathode led signals (not signals that use bulbs) We love model railways with light signals. You can operate them from toggle switches when you only have a couple of aspects to operate, but when it comes signals with more aspects the wiring can become complex. We were keen to provide a solution that would add some simple automation to 2-, 3- or 4-aspect signals, without the need for soldering, programming or making any additional connections. The power feed connects to two terminals, with up to 5 wires from the signal connecting to the remaining terminals (the ground terminal has two wires connected, the signal common and ground). You can power the module from 12V-25V DC, 12V to 16V AC, or from a DCC feed. The module reduces the supply voltage down to 12V to feed the signals. External resistors are not required, as these are built into the module. Simply drill an 8mm hole through the baseboard between the sleepers and insert the sensor from below (the sensor only needs a 2mm gap to see between the sleepers so there should be no problems with N gauge). Invisible infra-red light is projected upwards and any trains passing overhead will trigger the circuit and will operate the signal automatically. You can test this by waving your hand over the sensor, and the signal should operate. Detailed instructions:

Made by: BLOCKsignalling
Supplier Code: ASP1-NS
Availability: Last Chance
BLOCKsignalling Hide reviews

Customer reviews

Leave a review


The item has been added to your basket

Continue Shopping
Proceed To Checkout

This website is Copyright © 2021 Golden Valley Hobbies Limited. All Rights Reserved.

  • Paypal
  • Mastercard
  • Visa
  • JCB
  • Maestro
  • Payment gateway