SEQ1 BLOCKsignalling Sequence Controller for Led Effects

BLOCKsignalling

Availability: In Stock Out Of Stock
Code: BLOSEQ1

£16.99 £0.00
Earn 0 Rewards Points


Programmable Sequence Controller for Led Effects

  • Easy to wire and operate
  • Five outputs with independent timings
  • Pre-programmed so you can be up and running immediately
  • Can connect to a wide variety of supply voltages for easy powering
  • Each output can supply up to 100mA to power led effects
  • Separate permanently on output for permanently running effects
  • Timings and other settings can be adjusted if required


The Sequence Controller is designed to operate a number of model railway scenic features at timed intervals to provide a more random and so realistic operation.

There are five separate outputs which are switched individually.  Please see below for default timings.

One or more accessories can be connected to each channel and they will then switch on together.

Channel 1 is permanently on, so the module can be used to reduce the power supply voltage to feed effects which would normally be battery powered.

The output voltage is 3.5V and can power effects which would normally be supplied by two or three AA cells, or by two or three coin cells.

The timings for each channel are slightly randomised, so that channels will not change at exactly the same time.

 

 

Power Supply

The module operates from AC, DC or DCC (track bus) supplies.

You can use a DC power supply between 12V and 25V DC, or any AC power supply between 12V and 16V AC.

If using DCC, the feed can be between 12V and 25V, which covers all normal DCC layouts.

Where a choice is available, a 12V DC supply is recommended.


Made by: BLOCKsignalling
Supplier Code: SEQ1

The item has been added to your basket

Continue Shopping
Proceed To Checkout

This website is Copyright © 2019 Golden Valley Hobbies Limited. All Rights Reserved.

  • Paypal
  • Mastercard
  • Visa
  • JCB
  • Maestro
  • Payment gateway